The Glow Experiments

As with all my experimenting in the different aspects of the technique, Mokume Gane holds for polymer clay, I was thinking about the layering of the B/W  sheets and the purpose for each in revealing the design placed in the polymer clay ... hence, the experiment with glow clay was born!

* I am using Sculpey Glow polymer clay.

 First, condition your clay, I ran it through the pasta machine (you can do it by hand) on the thickest setting, as you can see it is already glowing!!!

 



 

In the picture above, I applied the silver leaf and alcohol inks of choice (teak, butterscotch,golds and a 'Lil raspberry) then, allow to completely dry.  Once dry, I rolled out a thin sheet of translucent polymer clay and laid it on top of the sheet that was inked, then rolled out a sheet of black on the thickest setting and laid that on top of the stack then, ran the entire stack through the pasta machine on the thickest setting.  You may cut your stack in half if it is more manageable and make a double stack or just use your single stacks to cut-in your design.

** side note:  ( the sheet of white has been omitted so the glow clay shows up nicely as, you have the black outlining your design).







Here are the slices that were obtained from my single stacks.  top: lights on - bottom: lights off
 

~~ * ~~

Below are a few completed projects made from the slices obtained from the stack I had created 

 

 

 

~~ * ~~

 

~~ * ~~